- Ikea chair
- 1 1/4 yards thin bonded leather fabric
- Sewing machine
- Leather sewing machine needle
- Heavy duty thread
- 1” wide velcro strip at least 20” long
- Gold spray paint
- Seam ripper
Assemble the chair frame according to the instructions. Spray paint the frame gold. You’ll want to do this outside or in a well-ventilated area, and on some cardboard or a plastic dropcloth. Spray it from all angles, in 2-3 light coats, to prevent drips. Let it dry 1 hour.
Use the seam ripper to open up the Ikea seat cover and separate each main piece (the top and bottom shape for the front and back, 4 pieces total). You won’t need the long skinny piece that runs the along the side of the chair, between the front and back of the cover. Make sure to rip up the seams of the hem, too, so you get the full width of the fabric.
Label each of the four pieces with a letter and label a picture of the finished chair with the same letters so you can remember how it goes together later.
Lay out the leather fabric (backside up) on the floor and trace each piece of the Ikea seat cover in sharpie. Write the corresponding letter on each piece.
Cut out each piece. Sew velcro strips onto the bottom pieces (in the same spot they are on the original covers).
Sew the top & bottom pieces together for the front and back of the chair.
Layer the front and back pieces, backsides facing out. Sew together along the outer edge leaving a ½” border. Flip the cover inside out.
Slide the chair cover on the frame and velcro the bottom.